We test all our products, to its max pressure and extended working conditions. Some cylinders are even tested for very high pressure with high pressure hand pumps.
- Computerized environment provided for design, planning, store and accounts.
- A fully automated setup along with monitoring at personal levels,
- Testing facility for high, low pressure simulation generation of any voltage and operational sequence,
- Fully documented inspection and testing procedure with 100% quality check
- Testing facility for high / low pressure and flow simulation.
- Generation of any voltage and operational sequence.
The frame is of all steel construction, fabricated from Rolled steel plates with suitable cross
ribbings. Presses Up to 30T will be supplied with C.I. legs. Proper alignment of the frame is
ensured by machining
The clutches of pin/rolling key-type. The clutch is rigid and well supported. The clutch gives
continuous Strokes for mass production.
Crank shaft is made of special alloy steel machined to close accuracy and tted in bronze
bushes for Smooth working, longer life & accuracy.
Properly sized Flywheel is made of high grade cast iron, for storing and releasing adequate
energy For the pressing operations, and properly balanced for smooth running.
Gears are of steel cast or fabricated. Gear teeth are generated by precision hobbing
Table & Ram
Table and Ram are made of high grade heavy duty cast iron & properly seasoned. They are
perfectly Aligned, to each other to obtain high accuracy & precision press operation.